Transient phenomena and impurity relocation in SIMS depth profiling using oxygen bombardment: Pursuing the physics to interpret the data

High detection sensitivity in bulk analysis or depth profiling by secondary ion mass spectrometry (SIMS) can only be achieved, for positively charged ions, if the nearsurface regions of the sputter eroded sample are fully oxidized. Using oxygen primary ions, a stationary oxidation state is established after some time of bombardment during which period the sputtering yield decreases and the ionization probability increases. The physical and chemical processes occurring during the transient period are reviewed with emphasis on the results for impurity analysis in silicon, i.e. the matrix material that has been studied most thoroughly in the past. The transient decrease in sputtering yield gives rise to a depth scale offset and an associated apparent shift of impurity profiles towards the surface. The effect is largest at normal beam incidence, ca. 1 nm/keV(O-2(+)) in which case silicon is fully oxidized. The transition depth, i.e. the depth sputtered before achieving a stable ion yield is about twice as large and increases as the impact angle is turned away from normal. The shift and the depth scale offset can be measured safely using thin (delta) layers of isotopically pure tracers, for example Si-30 in Si-28. Boron delta layers can serve as secondary standards because this impurity behaves almost the same as the host silicon atoms. The profile shift observed with other common dopants may contain contributions due to unidirectional relocation, often driven by segregation away from the surface. At O-2(+) energies below about 0.7 keV the transition depths fall below the thickness of typical native oxides, so that the transient changes in sputtering yield and ionization probability can disappear. The transient phenomena may be described by a simple sputtering-oxidation model that connects the depth scale offset to other observable parameters like the initial and final sputtering yield, the transition fluence and the oxide thickness.