The influence of polysilicon gate morphology on dopant activation and deactivation kinetics in deep-submicron CMOS transistors

In this paper, the impact of gate microstructure on the activation and deactivation kinetics of ion-implanted dopants is discussed. A comparison is made between large-grained polysilicon that was obtained by recrystallizing deposited amorphous silicon, and fine-grained polysilicon. Very good gate activation was achieved for both As- and B-implanted fine-grained polysilicon gates using post-implant rapid thermal annealing for 20s at 980-1010 degreesC, leading to gate depletion levels below 5%. Similar levels of gate activation are found for spike annealing of 1 s at 1100 degreesC. The kinetics of dopant deactivation in large- and fine-grained polysilicon have been measured in the temperature range from 700 to 800 degreesC. From these measurements, the loss in the gate activation due to extra annealing steps in a 0.13 mum CMOS process flow has been evaluated. Silicidation is the most harmful process step leading to an increase in the gate depletion level to 6% for a p-type fine-grained polysilicon gate, representing the worst case situation. Finally, TSUPREM-4 gate depletion simulations for future CMOS generations (less than or equal to 0.10 mum) have revealed the need of high dopant concentration (4-5 x 10(20)cm(-3)) which questions the possibility of polysilicon use as a gate material. (C) 2001 Elsevier Science Ltd. All rights reserved.