Structural analysis of Ti1-xSixNy nanocomposite films prepared by reactive magnetron sputtering

In this paper, we report on the preparation of thin films resulting from additions of Si to TiN matrix, by r.f. reactive magnetron sputtering. Results of X-ray diffraction (XRD) in both theta-28 and alpha-28 scans showed that a mixture of two phases is present, where the first is most likely fee TIN. The higher lattice parameter of this phase, about 0.429 nm (0.424 nm for bulk TiN). could be explained by taking into account that a correction of the residual stress effect on peak positions might slightly decrease the value of the lattice parameter (around 1%). Regarding phase 2, and although the exact nature of its composition is more difficult to evaluate, we believe that it is also a cubic lattice consisting of Ti-Si-N, where the Si could be occupying Ti positions within the TiN lattice. This would explain the low value of the lattice parameter. which by assuming a cubic structure would be 0.418 nm. Concerning texture evolution, phase 1 revealed some variations in preferential growth, which changed from [111] for low Si additions to [220] at intermediate Si additions and finally to a weak [200] texture for large Si additions. A small amorphous region of silicon nitride for large Si additions was also observed. Fourier analysis of XRD patterns showed a decrease in the size of grains for small Si additions when compared to that of TiN. For higher Si contents, only small changes were observed, although a decrease in grain size seems to be the main tendency. The grains are within the range of 4-6 nm. High-resolution transmission electron microscopy (HRTEM) on Ti0.63Si0.37N1.12 confirmed this nanocrystalline nature of the grains, revealing grains with sizes of about 2-3 nm. (C) 1999 Elsevier Science S.A. All rights reserved.