Effect of target thickness in blunt projectile penetration of Weldox 460 E steel plates

This paper describes an experimental, analytical and numerical investigation of the penetration and perforation of circular Weldox 460 E steel plates with different thicknesses struck by a blunt projectile at various impact velocities. In the experimental tests, a compressed gas gun was used to launch the sabot mounted projectile at impact velocities well above and just below the ballistic limit of the target plates. Nominal hardness, diameter, length and mass of the projectile were kept constant in all tests. The target plate was clamped in a rigid circular frame, and the thickness was varied between 6 and 30 mm. Measurements were made of the initial and residual velocities, and the ballistic limit velocity and the residual versus impact velocity curve were obtained for each target thickness tested. In addition, a digital high-speed camera system was used to photograph the penetration event. The experimental findings from the tests are presented and discussed, and the results are used to assess some empirical, analytical and numerical models. It is shown that especially the results obtained by the finite element approach are encouraging in terms of predicting the response of the plates examined. (C) 2002 Elsevier Science Ltd. All rights reserved.