On the aluminisation of stainless steel by CVD in fluidised beds

被引：33

作者：

Pedraza, F ^{[1
]}

Gómez, C ^{[1
]}

Carpintero, MC ^{[1
]}

Hierro, MP ^{[1
]}

Pérez, FJ ^{[1
]}

机构：

[1] Univ Complutense Madrid, Fac CC Quim, Dept CC Mat & Ingn Met, Lab Ingn Superficies Degradac & Durabilidad Mat, E-28040 Madrid, Spain

来源：

SURFACE & COATINGS TECHNOLOGY | 2005年 / 190卷 / 2-3期

关键词：

chemical vapour deposition; fluidised bed reactors; aluminide coatings; stainless steel;

D O I：

10.1016/j.surfcoat.2004.01.037

中图分类号：

TB3 [工程材料学];

学科分类号：

0805 ; 080502 ;

摘要：

The effect of coating parameters such as bed composition, H-2/HCl reactive gas ratio and temperature is investigated so as to obtain Al diffusion coatings on AISI 304 stainless steel substrates by chemical vapour deposition in fluidised bed reactors (CVD-FBR). It will be shown that thicker coatings are obtained when the beds are composed of AlCl3 (s) instead of pure Al powders. An increase in the reactive gas mixture also produces thicker coatings but some porosity may be found occluded in the proper coatings. Finally, moderate temperatures and times seem to be the most suitable to produce the best coatings avoiding the presence of sharp coating/substrate interfaces. A post-coating heat treatment brings about double-layered coatings based on FeAl and FexNiyAl containing Cr derivatives. (C) 2004 Elsevier B.V. All rights reserved.

引用

页码：223 / 230

页数：8

共 35 条

[11]

GREENWOOD NN, 1994, CHEM ELEMENTS, P1192

[12] FEASIBILITY OF FLUIDIZED-BED CVD FOR THE FORMATION OF PROTECTIVE COATINGS [J].