MICROSTRUCTURE-RELATED FRACTURE-TOUGHNESS AND FATIGUE-CRACK GROWTH-BEHAVIOR IN TOUGHENED, ANHYDRIDE-CURED EPOXY-RESINS

Fracture toughness and fatigue crack propagation (FCP) of plain and modified anhydride-cured epoxy resin (EP) were studied at ambient temperature. Liquid carboxyl-terminated acrylonitrile-butadiene (CTBN) and silicone (SI) rubber dispersions were used as tougheners for the EP. The morphology of the modified EP was characterized by dynamic mechanical analysis (DMA) and by scanning electron microscopy (SEM). The fracture toughness, K(c), of the compositions decreased with increasing deformation rate. K(c) of the EP was slightly improved by CTBN addition and practically unaffected by incorporation of the SI dispersion when tests were performed at low cross-head speed, v. Both modifiers improved K(c) at high v, and also the resistance to FCP, by shifting the curves to higher stress intensity factor ranges, DELTAK, by comparison with the plain EP. It was established that both fracture and fatigue performance rely on the compliance, J(R), at the rubbery plateau, and thus on the apparent molecular mass between crosslinks, M(c). The failure mechanisms were less dependent upon the loading mode (fracture, fatigue), but differed basically for the various modifiers. Rubber-induced cavitation and shear yielding of the EP were dominant for CTBN, whereas crack bifurcation and branching controlled the cracking in SI-modified EP. The simultaneous use of both modifiers resulted in a synergistic effect for both the fracture toughness at high deformation rate and the FCP behavior.