Structural properties of ZnSySe1-y/ZnSe/GaAs (001) heterostructures grown by photoassisted metalorganic vapor phase epitaxy

ZnSySe1-y/ZnSe/GaAs (001) heterostructures have been grown by photoassisted metalorganic vapor phase epitaxy, using the sources dimethylzinc, dimethylselenium, diethylsulfur, and irradiation by a Hg are lamp. The solid phase composition vs gas phase composition characteristics have been determined for ZnSySe1-y grown with different mole fractions of dimethylselenium and different temperatures. Although the growth is not mass-transport controlled with respect to the column VI precursors, the solid phase composition vs gas phase composition characteristics are sufficiently gradual so that good compositional control and lattice matching to GaAs substrates can be readily achieved by photoassisted growth in the temperature range 360 degrees C less than or equal to T less than or equal to 400 degrees C. ZnSe/GaAs (001) single heterostructures were grown by a two-step process with ZnSe thicknesses in the range from 54 nm to 776 nm. Based on 004 x-ray rocking curve full width at half maximums (FWHMs), we have determined that the critical layer thickness is h(c) less than or equal to 200 nm. Using the classical method involving strain, lattice relaxation is undetectable in layers thinner than 270 nm for the growth conditions used here. Therefore, the rocking curve FWHM is a more sensitive indicator of lattice relaxation than the residual strain. For ZnSySe1-y layers grown on ZnSe buffers at 400 degrees C, the measured dislocation density-thickness product Dh increases monotonically with the room temperature mismatch. Lower values of the Dh product are obtained for epitaxy on 135 nm buffers compared to the case of 270 nm buffers. This difference is due to the fact that the 135 nm ZnSe buffers are pseudomorphic as deposited. For ZnSySe1-y layers grown on 135 nm ZnSe buffers at 360 degrees C, the minimum dislocation density corresponds approximately to room-temperature lattice matching (y approximate to 5.9%), rather than growth temperature lattice matching (y approximate to 7.6%). Epitaxial layers with lower dislocation densities demonstrated superior optical quality, as judged by the near-band edge/deep level emission peak intensity ratio and the near band edge absolute peak intensity from 300K photoluminescence measurements.