Metallo-dielectric electromagnetic bandgap structures for suppression and isolation of the parallel-plate noise in high-speed circuits

A novel approach for the suppression of the parallel-plate waveguide (PPW) noise in high-speed printed circuit boards is presented. In this approach, one of the two conductors forming the PPW is replaced by an electromagnetic bandgap (EBG) surface. The main advantage of the proposed approach over the commonly practiced methods is the omnidireciional noise suppression it provides. For this purpose, two EBG structures are initially designed by utilizing an approximate circuit model. Subsequently, the corresponding band structures are characterized by analytical solutions using the transverse resonance method,as well as full-wave finite-element simulations. The designed EBG surfaces Were fabricated and employed in a number of PPW test boards. The corresponding frequency-domain measurements exhibited bandgaps of approximately 2.21 and 3.35 GHz in the frequency range below 6 GHz More importantly, suppression of the PPW noise by 53% was achieved based on time-domain reflectometry experiments, while maintaining the signal transmission quality within the required specifications for common signaling standards.