Nucleation and growth of nanophasic CeO2 thin films by plasma-enhanced CVD

被引:72
作者
Barreca, D
Gasparotto, A
Tondello, E
Sada, C
Polizzi, S
Benedetti, A
机构
[1] Univ Padua, CNR, ISTM, Padova Sect, I-35131 Padua, Italy
[2] Univ Padua, Dipartimento CIMA, I-35131 Padua, Italy
[3] INFM, I-35131 Padua, Italy
[4] Univ Padua, Dipartimento Fis, I-35131 Padua, Italy
[5] Univ Ca Foscari Venezia, Dipartimento Chim Fis, I-30170 Venice, Italy
关键词
CeO2; nanophasic thin films; nucleation; PECVD; surface techniques;
D O I
10.1002/cvde.200306247
中图分类号
O646 [电化学、电解、磁化学];
学科分类号
081704 ;
摘要
Nanophasic CeO2-based thin films were grown at low temperatures on SiO2 and Si(100) by plasma-enhanced (PE) CVD from a Ce-IV beta-diketonate first generation precursor. Film depositions were carried out in low-pressure Ar-O-2 plasmas at temperatures between 150degreesC and 300degreesC. The film microstructure was investigated by glancing incidence X-ray diffraction (GIXRD) and transmission electron microscopy (TEM), while the surface and in-depth chemical composition was studied by X-ray photoelectron spectroscopy (XPS), and secondary ion mass spectrometry (SIMS), respectively. Optical properties were analyzed by UV-vis optical absorption. Nanostructured CeO2-based films, with crystal size less than 6 nm and a controllable Ce-IV/Ce-III ratio, were obtained at temperatures even lower than that required for precursor vaporization (170 degreesC). In particular, TEM analyses showed an island growth mode and different microstructural features as a function of the substrate used.
引用
收藏
页码:199 / 206
页数:8
相关论文
共 86 条
  • [21] Sidewall and surface induced damage comparison between reactive ion etching and inductive plasma etching of InP using a CH4/H-2/O-2 gas mixture
    Etrillard, J
    Heliot, F
    Ossart, P
    Juhel, M
    Patriarche, G
    Carcenac, P
    Vieu, C
    Puech, M
    Maquin, P
    [J]. JOURNAL OF VACUUM SCIENCE & TECHNOLOGY A, 1996, 14 (03): : 1056 - 1061
  • [22] Reaction of NO on CeO2 and Rh/CeO2 thin films supported on α-Al2O3(0001) and YSZ(100)
    Ferrizz, RM
    Egami, T
    Wong, GS
    Vohs, JM
    [J]. SURFACE SCIENCE, 2001, 476 (1-2) : 9 - 21
  • [23] A comparative study of partial reduction of ceria via laser ablation in air and soft chemical route
    Filotti, L
    Bensalem, A
    BozonVerduraz, F
    Shafeev, GA
    Voronov, VV
    [J]. APPLIED SURFACE SCIENCE, 1997, 109 : 249 - 252
  • [24] HIGH-TEMPERATURE OXYGEN SENSOR-BASED ON SPUTTERED CERIUM OXIDE
    GERBLINGER, J
    LOHWASSER, W
    LAMPE, U
    MEIXNER, H
    [J]. SENSORS AND ACTUATORS B-CHEMICAL, 1995, 26 (1-3) : 93 - 96
  • [25] Influence of water and hydrocarbon processed in feedstream on the three-way behaviour of platinum-alumina catalysts
    GonzalezVelasco, JR
    Botas, JA
    GonzalezMarcos, JA
    GutierrezOrtiz, MA
    [J]. APPLIED CATALYSIS B-ENVIRONMENTAL, 1997, 12 (01) : 61 - 79
  • [26] Process development of methane-hydrogen-argon-based deep dry etching of InP for high aspect-ratio structures with vertical facet-quality sidewalls
    Grover, R
    Hryniewicz, JV
    King, OS
    Van, V
    [J]. JOURNAL OF VACUUM SCIENCE & TECHNOLOGY B, 2001, 19 (05): : 1694 - 1698
  • [27] Reactive ion etching of indium nitride using CH4 and H2 gases
    Guo, QX
    Matsuse, M
    Nishio, M
    Ogawa, H
    [J]. JAPANESE JOURNAL OF APPLIED PHYSICS PART 1-REGULAR PAPERS SHORT NOTES & REVIEW PAPERS, 2000, 39 (9A): : 5048 - 5051
  • [28] Characterization of ceria yttria stabilized zirconia grown on silicon substrate
    Hartmanova, M
    Gmucova, K
    Jergel, M
    Thurzo, I
    Kundracik, F
    Brunel, M
    [J]. THIN SOLID FILMS, 1999, 345 (02) : 330 - 337
  • [29] Dielectric properties of ceria and yttria-stabilized zirconia thin films grown on silicon substrates
    Hartmanova, M
    Gmucova, K
    Thurzo, I
    [J]. SOLID STATE IONICS, 2000, 130 (1-2) : 105 - 110
  • [30] Optical constants of nanocrystalline lanthanide-doped ceria thin films with the fluorite structure
    Hartridge, A
    Krishna, MG
    Bhattacharya, AK
    [J]. JOURNAL OF PHYSICS AND CHEMISTRY OF SOLIDS, 1998, 59 (6-7) : 859 - 866